2-6 sync, 2-7 blc =back light compensation, 2-4 shutter – Toshiba IK-64DNA User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7-2-4 SHUTTER
Exposure time setting in AES (MES)
position of iRiS switch on rear of the
camera
Move the cursor to the position in Fig.
Use the SELECT switches to select
AUTO,1/60, 1/100, 1/250, 1/500, 1/1K,
1/2K, 1/4K, and 1/1 OK
\
D/N MODE
AUTO
D/N LEVEL
HIGH
D/N FIL
ON
SHUTTER
дшд
GAIN
STD
SYNC
LL
BLC
OFF
SHARPNESS
HIGH
WHITE BAL.
AUTO
NEXT EXIT CANCEL DEFAULT
IQ ****************
IDPOS
OFF
BACK EXIT
CANCEL DEFAULT
k.
A
AUTO: Exposure time is controiied automaticaliy within a range of 1/60 sec,
to 1/100,000 sec to obtain an adequate signai.
1/60, 1/100, 1/250, 1/500, 1/1K, 1/2K, 1/4K, and 1/10K: Manuai shutter
( When an auto iris lens is used, it will display as IRIS.)
7-2-5 GAIN =AGC gain setting
Move the cursor to the position in Fig.
Use the SELECT switches to select
STD, HIGH
STD: Standard position, max gain= 21 dB
HIGH:High-Sensitivity position, max gain
= 30dB
(If there is noise in low light
conditions, set to STD.
r
D/N MODE
AUTO
D/N LEVEL
HIGH
D/N FIL
ON
SHUTTER
AUTO
GAIN
шз
SYNC
LL
BLC
OFF
SHARPNESS
HIGH
WHITE BAL.
AUTO
NEXT EXIT CANCEL DEFAULT
1Q ****************
IDPOS
OFF
BACK EXIT
CANCEL DEFAULT
-11 -
7-2-6 SYNC
Move the cursor to the position in Fig.
Use the SELECT switches to select INT, LL
INTThe camera is in the internal SYNC
mode.
LL: The camera is in the Line-Lock
mode. Line-Lock phase is set 0-300
degrees by adjusting the V-phase control
at the rear of the camera.
(Refer to 5.Con ections and Operations)
r
D/N MODE
AUTO
D/N LEVEL
HIGH
D/N FIL
ON
SHUTTER
AUTO
GAIN
STD
SYNC
!!■
BLC
OFF
SHARPNESS
HIGH
WHITE BAL.
AUTO
NEXT EXIT CANCEL DEFAULT
IQ ****************
ID POS
OFF
BACK EXIT
CANCEL DEFAULT
л
7-2-7 BLC =Back light compensation
Move the cursor to the position in Fig.
Use the SELECT switches to select
OFF, BLC1, BLC2, BLC3, BLC4
Using in AES or auto iris lens, the
exposure adjustment is automatically
controlled so that the best picture is
obtained at next monitor zone. This
function is effective when strong light
enters and auto iris lens closes.
OFF: The camera is not BLC mode.
r
D/N MODE
AUTO
D/N LEVEL
HIGH
D/N FIL
ON
SHUTTER
AUTO
GAIN
STD
SYNC
LL
BLC
1ДЗЗ
SHARPNESS
HIGH
WHITE BAL.
AUTO
NEXT EXIT CANCEL DEFAULT
IQ ****************
IDPOS
OFF
BACK EXIT
CANCEL DEFAULT
A
OFF
BLCl
BLC2
BLC3
BLC4
Video monitor
Video monitor
ra
Video monitor
Video monitor
Video monitor
в
H
-12-