Toshiba IK-64DNA - Manual (Page 5)

5-4 Back-Focus Adjusment
Back focus is adjusted at the factory to accommodate most standard lenses. If a
slight adjustment Is needed, mount the lens to the camera first. Then loosen the
Focus Lock Screw. Rotate the Focus ring until a clear image is achieved. Retighten
the Focus Lock Screw.
Focus Lock Screw
Note
When the lens weight is more than
1 kg (2.2 lbs), support the camera on the lens side
rather than relying on the tripod mount of the camera.
Focus Ring
5-5 Lens
This camera supports two types of auto
-iris lens: Video-type and DC (direct drive)
types. Connect the auto-iris connector
plug to the IRIS terminal on the side of
the camera. Refer to the chart below for
correct wiring and set up.
IRIS
Auto iris lens
Video IRIS
Lens
Direct Dirve
IRIS Lens
IRIS
terminal
pin
1.-I- 12V 1. Damp-(y)
2. NC 2. Damp+( r )
3. VIDEO 3. Driver+(wh)
4. GND 4. Driver-(g)
IRIS
Switch
VIDEO
position
DC
position
- 7 -
6. LINE LOCK PHASE
When a video switcher switches two or more
cameras, the picture may fluctuate on the video
monitor due to the different AC line phase of
each camera. In this case, adjust the V PHASE
controller (on rear panel) to get a stable image.
7. MENU DRIVEN SET-UP
The following Is the on-screen menu structure for
all settings and adjustments of the camera.
MENU
I D/N MODE ] d) I AUTO \-------------1 MANUAL ]
I D/N level ] Id) I LOW I --------------------- 1 HIGH |
|D/NFIL I l=> I ON I---------------------1 OFF I
I SHUTTER ] l=> I AUTO |—| 1/60 H 1/100~|j 1/250 [-^/500 |—|
1 — 1 1/1K 1-1 1/2K H 1/4K H 1/10K I
GAIN
SYNC
I STD [-[ high
|=> III [-[¡NT
I SHARPNES^ III>| HIGH |— | MID HT l OW |
^ l=> I AUTO I-TÌNDOOR IT^ utdoor |—j
L| RGAIN:00-63|-| BGAIN:00-63|
WHITE BAL.
ID.
****************
—IlDPOS I l=> I OFF I 1 TOP I—I BOTTO
D/N control ] d> |RS-422 |------------ | b .C.G |
SUB
MENU
jADDRESS I III> |001-255 j
-|pROTOcoL~| i=> | toshiba - p ]—| toshiba - d ~
( bit RATE 1 l=> 11200 |—12400~|—I^BOO |—19600
jsOFTVER. I m> I**" I
-8-