Toshiba IK-64DNA - Manual (Page 6)

Switch name
Select
▼
A
7-1 .Setting switches and the functions
On the side panel of the cameras there are three push button switches as
shown below:
Main function
Setting mode calls ON/OFF, setting entry
Setting item selection (down)
Setting item selection (up)
7-2 On screen MAiN menu
The camera is adjusted using the on screen menu. Press and hold the select
switch on the side of the camera body 2 seconds until the menu appears on the
monitor. The blinked area represents the option to be set.
7-2-1 D/N MODE
Set up a day/night function automatically or
manually. Move the cursor to the position in
Fig.
Use the SELECT switches to select
AUTO, MANUAL
AUTO: When set to this mode, the
camera will change to COLOR
mode and B/W mode automatically
according to a subject's brightness.
MANUAL: When set to this mode, the camera
will change to COLOR mode and
B/W mode manually according to a
RS-422 commands or simple locking
switches (B.C.G). (Refer to 7-3 On
screen SUB menu)
D/N MODE CTng
D/N LEVEL HIGH
D/N FIL ON
SHUTTER AUTO
GAIN STD
SYNC LL
BLC OFF
SHARPNESS HIGH
WHITE BAL. AUTO
NEXT EXIT CANCEL DEFAULT
1Q ****************
IDPOS OFF
BACK EXIT CANCEL DEFAULT
à
- 9 -
7-2-2 D/N LEVEL
Set up a switchover point from B/W
mode to COLOR mode
Move the cursor to the position in Fig.
Use the SELECT switches to select LOW,
HIGH Under the AUTO mode, the switchover
point of brightness from COLOR mode to
B/W mode is 1.5 lx.
LOW : The switchover point of brightness
from B/W mode to COLOR mode is 4.5 lx.
HIGH :The switchover point of brightness from
B/W mode to COLOR mode is 7.5 lx.
(To switch between color mode and B/W
mode within a short time, use this setup.)
>
D/N MODE AUTO
D/N LEVEL I!lt4!l
D/N FIL ON
SHUTTER AUTO
GAIN STD
SYNC LL
BLC OFF
SHARPNESS HIGH
WHITE BAL. AUTO
NEXT EXIT CANCEL DEFAULT
lU.
IDPOS OFF
BACK EXIT CANCEL DEFAULT
J
7-2-3 D/N FIL = D/N FILTER
Set up a filter of CCD output in B/W
mode
Move the cursor to the position in Fig.
Use the SELECT switches to select
ON, OFF
ON: Y-signal filter of CCD output is
narrow in B/W mode. In this position,
the horizontal resolution is 480 TV
lines.
OFF: Y-signal filter of CCD output is
wide in B/W mode. In this position,
the horizontal resolution is 570 TV
lines. (If there is horizontal noise in
B/W mode, set to ON.)
-------------------------------------^
D/N MODE AUTO
D/N LEVEL HIGH
D/N FIL En
SHUTTER AUTO
GAIN STD
SYNC LL
BLC OFF
SHARPNESS HIGH
WHITE BAL. AUTO
NEXT EXIT CANCEL DEFAULT
10 ****************
IDPOS OFF
BACK EXIT CANCEL DEFAULT
s_________________
-10-