VTech 900I - Manual (Page 6)

GEOTNG STARTED
GETTING STARTED
Setting Up Your yrec/7 900/
1. Choose an area near an electrical
outlet and a telephone wall jack.
0
©
0
AC TELEPHONE
ELECTRICAL WALL
OUTLET JACK
4, Plug the AC power adapter into an
electrical outlet. The ON/OFF LED
will flash during initialization for
about 20 seconds. After initialization
ofthelTAD, the LCD clock display
will flash until it is set.
r
NOTE: Connect power to the base unit
before placing the handset in the cradle.
U
4. Set the TONE/PULSE switch on
2. Install optional 9V back-up battery
in compartment located on
underside of 900/ base unit. This
battery retains memory in the event
of a power outage. VTech
recommends the use of an alkaline
battery.
......
3. Connect the telephone line cord.
Insert one end of the telephone line
cord into the jack at the rear of the
base unit. Plug the other end into a
telephone wall jack. Make sure the
plugs snap securely into place.
the base unit. If you have touch
tone service on your phone line, set
the switch to TONE. If you have
rotary service, set the switch to
PULSE.
5. Fill in the telephone number card
on the base unit.
6. CHARGE THE HANDSET
BATTERIES BEFORE USE.
The batteries recharge
automatically wheneverthe handset
is in the base unit cradle. The
batteries must be charged for 24
hours before using your phone for
the first time. The CHARGE LED
will flash until the handset is placed
in the base cradle and the batteries
are charged.
7. CHECK FOR A DIAL TONE.
After the batteries are charged, pick
up the handset and press the
PHONE key. The PHONE indicator
should light up, and you should
hear a dial tone. If not, see IN
CASE OF DIFFICULTY.
CAUTION:
1. Neverinstalltelephonewiringduring
a lightning storm.
2. Never install telephone jacks in wet
locations unless the jack is
specifically designed for wet
locations.
3. Never touch uninsulated telephone
wires or terminals unless the
telephone
line has been
disconnected at the network
interface.
4. Use caution when installing or
modifying telephone lines.