Erase, Repeat, Stop – VTech 900I User Manual
Page 13: Play, Skip, Initial set-up, Ring type programming, Security code programming, Initial power-up, Ring type programmi security code programming
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
mGRmmEPHOlAN^MGDraCfilTADl-OPEMTO^
Message Playback Keys
ERASE ........
• The ERASE key is used to delete old
messages (previously reviewed) from
the ITAD.
• Pressing ERASE during message
playback deletes that message.
• If this key is pressed and held for more
than 2 seconds, all old (previously
reviewed) messages in the current
mailbox selection will be deleted (This
feature works only when the
answering machine is idle; it does not
work during message playback).
• To prevent accidental deletion of new
messages, you are not able to delete
a message unless it has been listened
to first!
ERASE
•
TO REPLAY
CURRENT PLAYING
MESSAGE :
Q PRESS I q • TO REPEAT PREVIOUS PRESS REPEAT • The REPEAT key is used to return to the beginning of a message during • If this key is pressed prior to a message, the previous message will • The previous message will also begin if this key is pressed twice quickly STOP • TO STOP MESSAGE PLAYBACK • TO STOP MEMO RECORDING • TO STOP ANNC. RECORDING • TO EXIT SET-UP MODE PRESS STOP current mode of operation and return • Use STOP to stop message playback, stop memo or announcement recording, or exit the set-up mode. PLAY •The PLAY key is used to begin playback of all messages/memos selection (the default mailbox selection is All). • This key is also used to play the current announcement message by SKIP I TO PLAY NEXT MESSAGE: PRESS SKIP beginning of the next message during INITIAL SET-UP seconds to enter the set-up mode or Ring Type Programming The ITAD has 3 ring type settings: 2 rings The incoming call is answered after 2 rings. 4 rings The incoming call is answered after 4 rings. Toll Saver The incoming call is answered after 2 rings only if there are new messages/ present in memory; otherwise, answers call after 4 rings. Thus, if Toll Saver is active To change ring type setting: 1. Press and hold the SETUP key for 2 seconds. The ITAD will beep and 2. Use the REPEAT and SKIP keys to scroll to the desired ring type. 3. Press the SETUP key to exit ring type programming mode, and to security code programming, or press the STOP Security Code Programming The security code programmed into The security code default setting is 99. 22 23
MESSAGE
message playback.
begin.
during message playback. •
•The STOP key is used to exit the
to the ITAD Standard operationmode.
(new and old) in the current mailbox
pressing and holding it for more than
2 seconds.
•The SKIP key advances to the
message playback.
Press the SETUP key for more than 2
until it beeps once. Here you can set
the ring type, security code, time/day
and mailbox programming as follows.
memos
and your ITAD rings 3
times when you call, you
can hang-up to avoid any
long distance charges.
the LCD will display "rt"(ring type)
and the current ring type setting.
Forward selection is in the following
order 2 rings, 4 rings, Toll saver.
advance
key to exit the set-up mode, and
the ITAD is used to gain access to the
functions from remote locations.