VTech 900I - Manual (Page 22)

®iC:(3^and IC REGULATIONS
<"i
This equipment complies with Parts 15
and 68 of the Federal Communications
Commission (FCC) rules forthe United
States. It also complies with regulations
RSS-210 and CS-03 of Industry
Canada (IC).
A label Is located on the underside of
the base unit containing eitherthe FCC
registration
number and Ringer
Equivalence Number (REN) or the IC
registration number and Load Number
(LN). You must, upon request, provide
this information to your local telephone
company.
This equipment is compatible with
inductively coupled hearing aids.
Should you experience trouble with
this telephone equipment, please
contact;
In the United States:
VTECH COMMUNICATIONS
1-800-624-5688
In Canada:
VTECH ELECTRONICS
1-800-267-7377
for repair/warranty information. The
telephone company may ask you to
disconnect this equipment from the line
network until the problem has been
corrected.
Your VTech 900i'\s designed to operate
at the maximum power allowed by the
FCC and IC. This means your handset
and base unit can communicate only
over a certain distance - which will
depend on the location of the base unit
and handset, weather, and the
construction and layout of your home
or office.
If you move the handset out of range
during a phone conversation, you will
hear an ‘Out of Range’ tone to tell you
to move closerto the base. If you do not
move within range within 30 seconds
the call is automatically disconnected.
If you move out of range when the
handset is in standby mode, it will give
an 'Out of Range’ tone to tell you that
the handset will not be able to receive
or place calls. You may terminate the
‘Out of Range’ tone by pressing any
number key on the handset.
FCC Part 15
Warning: Changes or modifications to
this unit not expressly approved by the
party responsible for compliance's could
void the user’s authority to operate the
equipment.
______________
The equipment has been tested and
found to comply with part 15 of the FCC
rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment
does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try and correct
the interference by one or more of the
following measures:
40
FCC and IC REGULATIONS
- Reorient or relocate the receiving
antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into an
outlet or on a circuit different from
that to which the receiver is
connected.
- Consult the dealer or an
experienced radio/TV technician for
help.
FCC Part 68
The FCC requires that you connect
your cordless telephone to the
nationwide telephone network through
a modular telephone jack (USOC
RJIICor RJ11W).
Your telephone company may
discontinue your service if your
equipment causes harm to the
telephone network. They will notify you
in advance of disconnection, if possible.
During notification, you will be informed
of your right to file a complaint with the
FCC.
Occasionally, yourtelephone company
may make changes in its facilities,
equipment, operation, or procedures
that could affect the operation of your
equipment. If so, you will be given
advance notice of the change to give
you an opportunity to maintain
uninterrupted service.
The base unit contains no user
serviceable
parts. The handset
contains a user replaceable battery
pack.
If it is determined that your telephone
equipment is malfunctioning, the FCC
requires that it not be used and that it be
unplugged from the modular jack until
the problem has been corrected.
Repairs to this telephone equipment
can only be made by the manufacturer
or its authorized agents or by others
who may be authorized by the FCC.
For repair procedures, follow the
instructions outlined under the VTECH
Limited Warranty.
This equipment may not be used on
coin service lines provided by the phone
company or on party lines.
The REN is useful in determining the
number of devices you may connect to
your telephone line and still enable the
devices to ring when you receive a call.
The general rule is that the REN value
should not exceed 5.0A total; however,
contact your local telephone company
for the specific number in your area.
41