Tax table setting – Toshiba TEC MA-71 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
El-01402
TAX TABLE SETTING
The MA-71 model can automatically calculate tax using one of the following three methods.
1. FULL-BREAK METHOD (Combination of Non-Cyclic Breaks and Cyclic
Breaks; maximum 32 breaks programmable)
2. COMBINATION OF NON-CYCLIC BREAKS AND % RATE
(maximum 32 breaks programmable)
3. % RATE ONLY
(cO^DiTfON ) After Daily Reset
(
q
PERATIQN) Mode Lock: SET
1. FULL-BREAK METHOD
Non-cvciic Breaks
1 ) Enter the first break point of price that is the non-taxable limit, and depress
[TX/M],
2) Enter the next break point of price that is the limit to collect the tax amount of
10, and depress [TX/M].
3) Repeat Step 2) above, with alternating each limit price for collecting tax amount
of 20, 30, 40, . . . until the non-cyclic breaks are all entered.
4) Depress [ST] to end the non-cyclic break entries.
Cyclic Breaks
5) Do the same operation as Step 3) above, entering each limit price for each tax
amount that increases by 10, following by the [TX/M] key. Enter the last price
so that the difference between the last non-cyclic break price already entered
and the last cyclic one will be a multiple of one dollar ($9.00 maximum).
Otherwise, the tax calculation will not correctly function.
6) Depress [AT/TL] to complete the cyclic break entries and the entire tax
program.
-
42
-