Read (x) and reset (z) reports – Toshiba TEC MA-71 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
El-01402
9.
READ (X) AND RESET (Z) REPORTS
The following table shows available reports and the key operations to issue those respective
reports. The contents of the X and Z reports are the same if both are available, except that:
1. Symbol X for X (Read) reports, and Z for Z (Reset) reports are printed as the header.
2. A reset count is printed near the end of a Z report (but not on X reports).
3.
All the resettable counters and totals will be reset on a Z report issuance, while they will
not be reset on an X report issuance. Therefore, X reports may be taken at any time and
any number of times during the day or at the end of the day. But the Z report is
expected to be taken only once a day and usually at the end of the day.
TABLE OF X AND Z REPORTS
REPORT NAME
mm
LOCK
KEY OPERATION
Cash-in-drawer Read (Read only)
X
m
Daily Read
Daily Reset
X
z
] [AT/TL]
GT Read
X
] 20 [AT/TL]
GT Reset
z
Refer to the report print samples on the following pages.
page
Cash-in-drawer Read Report ............................................................................ 31
Daily Read or Reset Report .............................................................................. 32
(The program verification printings, which are available in the “X” position of the Mode
Lock, are located in the chapter VERIFICATION OF PROGRAMMED DATA.)
Cash-in-drawer Read Report (Read only)
Mode Lock; X, depress [#].
Read Report Symbol
Cash-in-drawer Amount
Consecutive No.
Date
-31
-