Toshiba KV-9096A - Manual (Page 24)

R
ecording operation
RECORDING
oz
5 0
oi=
CC<
ODC
OUJ
UjQ.
DCO
Turn on the power for this VCR as well as associated
devices of the surveillance system including the video
camera and monitor TV.
Insert a video cassette to this VCR.
• Check that the safety tab on the video cassette has
not been removed.
Adjust the monitor TV so that the picture from the
video camera is displayed properly.
Select the recording time mode.
y TIME MODE ^
O SET
551
n n n n SP /_/
H
j
Check that the date time display on the monitor TV is
correctly displayed.
Press the REC button.
»REC
8/28/97 THU
17;30;05 sp A 2
[ qd I
REC^ _ _ _ _
1 1 1 i M M SP i_i J
► U U M M
Set the various functions such as timer recording,
alarm recording, restart recording, tape end, etc.
Notes:
When the PAUSE button is pressed during recording, the VCR goes to the pause mode. To release, press either the PAUSE
button again or the REC button, if the VCR is in pause mode for longer than 10 minutes the VCR will automatically go into stop
mode to protect the video tape and heads.
Repeat recording, restart recording, alarm recording, etc. also operate during recording.
When recording is interrupted or the recording time is changed, the pictures may be disturbed at that location.
If a power failure should occur, it is possible to resume recording in the same time mode as long as the power is restored within
approximately 10 days.
During repeat recording, pay attention to the following points.
• Timer recording and alarm recording is not possible during automatic rewind.
• The buzzer does not sound even at tape end.
• When an operation button is pressed during automatic rewind, the repeat recording function does not operate. Reset to the
recording mode.
The time mode button is not accepted during alarm recording or timer recording.
Make sure to carry out daily check for repeat recording or timer recording.
23