Resetting the handset without the base, Changing the digital security code, Traveling out of range – Uniden Cordless Telephone User Manual

Page 71

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Resetting the Handset without the Base

If your original base is not available for some reason (for example, it is lost or somehow incapacitated), you can still

reset the handset and use it with another base.

1) Press and hold [■)] and [#] for more than 5 seconds.

2) Move the cursor to select BASE UNAVAILABLE and then press the

soft key.

BASE UNAVAILABLE appears.

3) Move the cursor to select YES, and then press the

soft key. ARE YOU SURE?

appears.

4) Move the cursor to select YES, and then press the

soft key. You will hear a confirmation tone. The hand

set will delete its own base information without trying to contact the base. When the base information is delet
ed, the handset displays MODELS VARY! PLACE HANDSET ON THE BASE FOR REGISTRATION OR RE

FER TO OWNER’S MANUAL. Register the handset to the new base (see page 25).

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from the

manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you

suspect another cordless telephone is using the same security code or if you are instructed to change this code by a

manufacturer’s Call Center Representative, you can change the code by:

1. Perform “Resetting the Handset” for all of your handsets.

Re-register each handset by following the steps on page 25.

Traveling Out of Range

During a call, if you move your handset too far away from your base, noise may increase. If you pass the range limits

of the base, you will hear a beep and see OUT OF RANGE on the display, and then the handset returns to standby.