Activate the dolby pro logic mode, How to calculate the proper delay time, I l j i – Kenwood KR-V5560 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

w
I This mode provides a similar Dolby Surround effect used in movie theaters when a video (or LD| software programs carrying the
i CniPowawiBotitMi mark is piayed.
/
Activate the DOLBY PRO LOGIC mode.
(D
[) Select the center mode using a
sharp object (such as a ball-point
pen).
Each press of the CEWTER MODE key switches the center modes ae
follows:
C
® NORMAL : When the center speaker is a compact-sized spe.
® WIDEBAND : When the center speaker is a medium- or large-
speaker,
@ PHANTOM : When the center speaker is not used.
• If you cannot tell whether your center speaker is compact or me
dium-sized, try two modes and select according to your liking.
• The selected center mode is automatically stored in memory anc.
held unless, it is changed later.
► The test tone which is heard like noise moves between speakers a
an interval of 1.5 sec.
In NORMALand WIDEBAND
modes:
:
Left tL]
Center (C)
Right ¡R)
Surround (Rear) (S)
In PHANTOM mode;
c
Left (U
Right (R)
Surround (Rear) (S)
SPEAKEfiS
O
VIDEO
rre T
i L J i
I
L
» Be sure to adjust from your listening position.
►
When a key is pressed, the corresponding volume level to tKe key is
displayed on the display, While the level is displayed, it can be ad
justed by 1 dB per press of the key.
►
The volume levels can be adjusted in thejange from -10 dB to +1C
dB,
How to calculate the proper delay time
I When the DELAY TIME key is pressed, the delay time is displayed
on the display.
I The delay time can be adjusted in the range from 15 ms to 30 ms, in
5 ms steps,
I Set the closest value to the value obtained with method (1) or (2)
below.
I Once the delay time has been preset, it is held until it is re-set later.
0 Use the delay time calculation chart below;
Example: When A = 3 m,
B = 3m, the delay time
is 20 ms.
0 Use the following formula for calculation.
Delay time = 20 + 3 x (A - B) [Unit; ms)