No operation off, Basic adjustment settings, Pescripli.pn t – Sharp Aquos LC 42D43U User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic adjustment settings
:;PQ#ffiG0ritrd|v;::;
Power control setting allows you to save energy.
No signal
off
When set to “Enable”, the power will automatically shut
down if there is no signal for 15 minutes.
Press
MENU
to display the MENU screen, and
then press Mip- to select “Power Control”.
raC I Press A.-'T to select “No Signal Off’, and then
press
enter
.
Press <■■> to select “Enable”, and then press
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press
MENU
to exit.
• “Disable” is the factory preset value.
• When a W program finishes, this function may not operate.
No operation
off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Press
MENU
to display the MENU screen, and
then press to select “Power Control”.
Press ^/T to select “No Operation Off”, and
then press
ENTER
Press -ENTER.
® Five minutes before the power shuts down, the
remaining time displays every minute.
Press
MENU
to exit.
•
This setting allows you to optimize the settings of
Digital broadcasting.
■I: Audio^ Setup 11: y ;Urrfrrrrr:F'.'.'.'.'.'.'.'.V; l iF: I IF:V.“rrrrrrrr:F:
You can output digital audio to an AV amplifier or
similar device whose DIGITAL AUDIO INPUT terminal
is connected to the DIGITAL AUDIO OUTPUT terminal
on the TV. Please select an audio output format
compatible with the audio format of the program you
are watching and the equipment connected.
Press
MENU
to display the MENU screen, and
then press to select “Digital Setup”.
Press A/V to select “Audio Setup”
press
ENTER.
and then
Press A/T to select “PCM” or “Dolby Digital"
and then press
ENTER.
Selejcteditem-
PCM
Dolby Digital
Pescripli.pn t
The optica! output terminal outputs audio
signal in PCM form. If your digital audio
system does not support Dolby Digital,
select “PCM".
The optica! output terminal outputs audio
signal in Dolby Digital form. It reproduces
sound from surround program of digital.
Press
MENU
to exit.
• “Disable" is the factory preset value.
m - 29