Sharp Aquos LC 42D43U - Manual (Page 19)

Watching TV
Si:rnpfè.;b;iJttorì^Jppèr^
piiartgfng:-chàririéis;-■ ■
Y'-:u ''"an change channels in several ways.
o
CZD
— VO l + X/- CH Wv. INPUT POWilR
Method 1
Using CH A/V on the remote control unit or on the
TV.
Method 2
(T) Press FLASHBACK to switch to the previously
tuned ohannel.
(2) Press FLASHBACK again to switch back to the
currentiy tuned channel.
» FLASHBACK will not work if no channel has been
changed after the TV is turned on.
Method 3
Using remote control buttons 0-9, « (DOT) to select
channels for VHF/UHF/CATV/DIGITAL,
To select a 1 or 2-digit channei number
(e. g., Channel 5):
Press SwENT
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
® When you enter 0-9 only, channel selection will be made If
there is no operation within a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1w.i^5^ENT
_______
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 (DOT) wl^ENT
!if
•
When you enter 0-9 only, channei selection will be made if
there is no operation within a few seconds,
if you push “0" by itself, nothing will happen.
Complete the above steps within a few seconds.
When you enter 0-9 and • (DOT, channel selection will be
made if there is no operation within a few seconds.
18