Sharp Aquos LC 46SE94U - Manual (Page 49)

Appendix
RS-232G Port Spècificatións
I PC control of the TV
Attach an RS-232C cable cross-type (commercially
available) to the supplied Din/D-Sub RS-232C for the
connections.
• This operation system should be used by a person who Is
accustomed to using computers.
■ Communication conditions
Set the RS-232C communication settings on the PC to
match the TV's communication conditions.
The TV's communication settings are as follows:
I Command format
Eight ASCII codes + CR
C1 C2 C3 C4 P1 P2 I P3 P4
9,600 bps
i>áta length: . 8 bits
Parity bit: : None
Sfopbil::' ■ V , V / 1 bit
Flowi-eontro!:;. ;y ;. ' ,01 None
Command 4-digits Parameter 4-digits Return code
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0-9, x, blank, ?
■ Parameter
Input the parameter values, aligning left, and fill with
blank(s) for the remainder. (Be sure that 4 values are
input for the parameter.)
When the input parameter is not within an adjustable
range, "ERR” returns. (Refer to “Response code format”.)
Any numerical value can replace the “x” on the table.
■ Communication procedure
Send the control commands from the PC via the RS-
232C connector.
The TV operates according to the received command
and sends a response message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before
sending the next command.
■ Command table
® Commands not indicated here are not guaranteed to operate.
When “?” is input for some
commands, the |---^—
present setting I ?
value responds. i i
I Response code format
Norma! response Problem response (communication
error or incorrect command)
о : К
.fr...
Ì
Return code (ODH) 4 Return code (ODH)
CONTROL ITEM COMMAND PARAMETER CONTROL CONTENTS
POWER ON COMMAND SETTING R s P W OFF The Power On command rejected.
ON The Power On command accepted.
POWER SETTING P c W R Power Off It shifts to standby.
Power Ол Power On
INPUT SELECTfON A TOGGLE I G D (Toggle) It input-siwitches by the toggle, (It is the same as an input change key)
TV I V D It input-switches to TV. (A channel remains as it is. (Last memory))
1NPUT1 -7 A V D Input terminal number (1 -7) It input-switches to INPUT1 ~INPUT7,
INPUT SELECTfON В INPUT 1 N P 1 0: AUTO, 1; VIDEO. 2: COMPONENT An input ohange is also included.
INPUTS N P 3 0: AUTO, 1: VIDEO. 2: COMPONENT
AV MODE SELECTION A V M D - - - 0: (Toggle), 1: STANDARD, 2: MOVIE, 3: GAME, 4: USER,
5: DYNAMIC(Fked), 6: DYNAMIC, 7: PC, 8: wYCC Although it can choose new, it is toggle operation in inside.
VOLUME V 0 L M Volume (0-60)
posmoN H-POSITION H p 0 S The screen position variable ranges depend on the View Mode or the
signal type. The ranges can be seen on the position-setting screen. V-POSITION V p 0 s
CLOCK C L C к OnV PC mode, (CF1&0)
PHASE P H s E
_
Only PC mode. (0-40)
VIEWMODE w D E 0: (Toggle) |AV], 1: Side Bar [AV], 2; S.Stretch [AV]
3: Zoom [AV], 4: Stretch [AV], 5; Normal [PC]
6: Zoom [PC], 7: Stretch [PC],
8; Dot by Dot [PC] [AV], 9: Full Screen [AV] 0; Although it can choose now. it is toggle operation in inside.
1: Only available when 4:3 signal is being input.
5, 6: Only available when 4:3 signal is being input.
8: [PC] Available except when UXGA is being input
[AV] Only available when 1080i/p is being input.
9: Only available when 720p is being input.
MUTE M u T Ё 0: (Toggle), 1: On, 2: Off
SURROUND A c s U 0: (Toggle), 1: On, 3; Off
AUDIO SELECTION A c и
A (Toggle)
SLEEP TIMER 0 F T M - - - 0; OFF. 1: OFF TIMER - 30 WIN., 2: OFF TMER - 60 MIN.,
3: OFF TIMER - 90 MIN,, 4: OFF TIMER - 120 MIN.
CHANNEL DIRECT
CHANNEL
(ANALOG) D c C H - The diannel number of TV
(1-135)
An input change is included it it is not TV display.
In Air; 2-69ch is effective.
In Cable. 1-136ch is effective.
DIRECT
CHANNEL
(DIGITAL) n A ? P (0100-9999) DIGITAL Air (Two-Pad numbers. 2-diqit plus 2-diqit)
D c 2 U - (1-999) DIGITAL Cable (Two-Patl numbers, 3-digit plus 3-digit)
Front half of DIGITAL CABLE CHANNEL NO. (Designate major channel)
D c 2 L
‘ ‘ ‘
- (0-999) DIGITAL Cable (Two-Pail numbers, 3-digit plus 3-digit)
Rear half of DIGITAL CABLE CHANNEL NO. (Designate minor channel)
D c 1 0 (0-9999) DIGITAL Cable (One-Pait numbers. 5-diai1, less than lO.OOOi
D c 1 1 (0-6383) DIGITAL Cable (One-Pait numbers. 5-diqit, more than 10,000)
CH UP C H u P The channel number of TV+1 If it is not TV display, it will input-switch to TV. (same function as CH/\)
CH DOWN C H D w The channel number ofTV -1 If it is not TV display, it will input-switch to TV. (same funclion as CH\/)
CC c L C p X (Toggle) Toggle operation of a closed caption.
ifîmÈ
if an underbar (J appears in the parameter column, enter a space.
If an asterisk (*) appears, enter a value in the range indicated in brackets under CONTROL CONTENTS.
Any numerical vaiue can replace the “x” on the table.
48