Label stick, To remove the tape backing, To transfer the label to paper – Brother P-TOUCH PC User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Label stick
The attached stick enables the label backing of the tape to be removed
easily. You can also use it to rub instant lettering tapes.
To remove the tape backing
1.
Hold the tape in the left hand with the printed surface upside,
and the stick in the right hand.
2.
Pass the tape halfway through the slot of the stick.
3.
After turning the stick inward halfway, pull the stick to the right.
To transfer the label to paper
Instant lettering tapes act as rub-on character transfers. After creating a
label, simply position the characters over a sheet of paper. By rubbing the
instant lettering tape's non-printed side with the attached label stick, you
can transfer the tape's contents directly onto paper.
Note:
Hold the paper very firmly and do not allow it to move while rub
bing the tape.