Pioneer SX-209RDS - Manual (Page 7)

FRONT PANEL FACILITIES
D)EON (Enhanced Other Network information)
MODE button/indicator
See page 15.
l|) Remote sensor
¡3) OPERATION DISPLAY panel
(a) (b) (c) (d) ( e ) ( f ) ( g )
I DIRECT I LOUDNESS
lonoff - i ...........................................................................
AM IVI IWI IVI IWI IVI IVI )r7 IVI
™ IKI lAI IKI. lAJ lAJ IKI IKI IK\
( k )
MEMORY RDS-
EON - I o
I LI ch
I___^__ I
- ( h )
- ( i )
( i )
( I ) ( m )
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
( l )
DIRECT ON/OFF indicator
LOUDNESS indicator
TAPE 2 monitor indicator.
CLASS indicator
MONO indicator
Lights up when a stereo FM broadcast is being received.
Lights up when a station is tuned.
RF ATT indicator
Lights when an RDS broadcast is received.
Lights when a station broadcasting EON information is re­
ceived.
Frequency, function, character display
MEMORY indicator
(m) Channel display
® CLASS button
Use to switch between preset memory classes 1 to 3. In each
class, one station can be memorized in each of the 1 to 10 STA­
TION CALL buttons, enabling a total of 30 stations to be memo­
rized.
©FM/AM selector button
This button is used to select either AM or FM reception.
©TUNING buttons (-, +)
Use for tuning frequencies. Press the buttons to change the fre­
quency display (3-speed Accel Tuning) (See page 9).
In the Manual Name input mode and PTY search mode, use to
select characters and program types.
©STATION buttons (- +)
+: Stations change in order in the upward direction.
Stations change in order in the downward direction.
® BASS tone control
Use to adjust low-frequency tones. The center position is the flat
(normal) position. When turned to the right, low-frequency tones
are emphasized.
NOTE:
This control can not be used when the DIRECT function is ON.
The DIRECT function can be turned ON/OFF using the remote
control unit.
©TREBLE tone control
Use to adjust high-frequency tones. The center position is the
flat (normal) position. When turned to the right, high-frequency
tones are emphasized.
NOTE:
This control can not be used when the DIRECT function is ON.
The DIRECT function can be turned ON/OFF using the remote
control unit.
® BALANCE control
Should normally be left in the center position. Adjust balance if
the sound is louder from one of the speakers. If the right side is
louder, turn toward the L position and if the left side Is louder,
turn toward the R position.
NOTE:
This control can not be used when the DIRECT function is ON.
The DIRECT function can be turned ON/OFF using the remote
control unit.