Pioneer SX-209RDS - Manual (Page 20)

Amplifier Section
Continuous Power Output (DIN)
1 kHz, T.H.D. 1 %, 4 Q........................................... 50 W + 50 W
Continuous Power Output (both channels driven)* **
20 Hz - 20 kHz, T.H.D. 0.09 %, 8 Q...................... 40 W + 40 W
Dynamic Power Output (with ElAtest signal)
4/8 0................................................................................80/50 W
Input (Sensitivity/Impedance)
PHONO................................................................. 2.5 mV/47 kO
CD, LD/DVD, TAPE 1A/CR, TAPE 2................... 200 mV/47 kO
Phono Overload Level (T.H.D. 0.1 %, 1 kHz)
PHONO.............................................................. ........... 100 mV
Output (Level/Impedance)
TAPE 1/VCR REC, TAPE 2 REC MONITOR ....... 200 mV/1 kO
Frequency Response**
PHONO (RIAA Equalization)......... 20 Hz to 20,000 Hz ± 0.5 dB
CD, LD/DVD, TAPE 1/VCR, TAPE 2...5 Hz to 100,000 Hz dB
Signal-to-Noise Ratio (DIN, continuous power/50mW)**
PHONO.................................................................... 67 dB/61 dB
CD, LD/DVD, TAPE WCR, TAPE 2.........................82 dB/62 dB
Tone Control
BASS..................................................................... ±8dB(100Hz)
TREBLE........................................................... ± 8 d B (10 kHz)
LOUDNESS............................................. +6dB(100Hzat-40dB)
+4 dB (10 kHz at -40 dB)
Miscellaneous
Power Requirements ................................. AC 230 Volts, 50/60 Hz
Power Consumption............................................................... 370 W
Dimensions................................ 420 (W) X 140 (H) X 313 (D) mm
Weight (without package)....................................................... 5.4 kg
Accessories Parts
FM Antenna................................................................................... 1
AM Loop Antenna.......................................................................... 1
Remote Control Unit...................................................................... 1
Dry Cell Batteries (AA/R6P) ......................................................... 2
Operating Instructions................................................................... 1
NOTE:
Specifications and design subject to possible modification with­
out notice, due to improvements,
* Measured by audio spectrum analyzer.
** Direct ON
FM Tuner Section
Frequency Range ........................................ 87.5 MHz to 108 MHz
Usable Sensitivity................................ 14.2 dBf, IHF (1.4 pV/75 Q.)
Sensitivity (DIN)
MONO...................................................................................... 1.0 pV/75n
STEREO................................................................... 40 pV/75 Q
Signal-to-Noise Ratio
MONO......................... ................................... 77 dB (at 80 dBf)
STEREO........... ............................................. 72 dB (at 80 dBf)
Signal-to-Noise Ratio (DIN)
MONO................................................................................. 62 dB
STEREO............................................................................. 58 dB
Distortion
STEREO.................................................................. 0.3% (1 kHz)
Alternate Channel Selectivity................................. 64 dB (400 kHz)
Stereo Separation...................................................... 40 dB (1 kHz)
Frequency Response............................... 30 Hz to 15 kHz (±1 dB)
Antenna Input..................................................... 75 Q unbalanced
AM Tuner Section
Frequency Range ......................................... 531 kHz to 1,602 kHz
Sensitivity
IHF, Loop Antenna.............. ................................. . 350 pV/m
Selectivity................................................................................. 20 dB
Signal-to-Noise Ratio............................................................... 50 dB
Antenna............................................................. AM Loop Antenna
MAINTENANCE OF EXTERNAL SUR­
FACES
• Use a polishing cloth or dry cloth to wipe off dust and dirt.
•
When the surfaces are very dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and wrung out well, and then wipe again with
a dry cloth. Do not use furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays and other
chemicals on or near this unit, since these will corrode the
surfaces.
PIONEER CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153, Japan
PIONEER ELECTRONICS [USA] INC. P.O. BOX 1540, Long Beach, California 90801-1540
PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R 0P2, Canada
PIONEER ELECTRONIC [EUROPE] N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium TEL: 03/570.05.11
PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia, TEL: [03] 9586-6300
PIONEER ELECTRONICS DE MEXICO S.A. DE C.V. San Lorenzo Num 1009 3er piso Desp. 302 Col. Del Valle, Mexico D.F. C.P 03100 TEL: 5-688-52-90
Printed in Belgium