Kenmore 790.4672 - Manual (Page 8)

About the Ceramic Glass Cooktop
The ceramic cooktop has radiant surface elements located below
the surface of the glass. The design of the ceramic cooktop outlines
the area of the surface element underneath. Make sure the
diameter of the pan matches the diameter of the element outline on
..... .....................
the cooktop (See Figure 1 ).
Heat is transferred up through the surface of the cooktop to the
cookware. Only flat-bottom cookware should be used. The type and :
size of cookware, the number of surface elements in use and their
settings, are all factors that will affect the amount of heat that will
spread to areas beyond the surface elements.
.............
The areas surrounding the elements may become
hot enough to cause burns.
Figure 1
About the Radiant Surface Elements
The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the
selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and
consistent heat during the off cycle. For energy efficient cooking, turn off the element several minutes before
cooking is complete. This will allow residual heat to complete the cooking process.
Locations of the Radiant Surface Elements and Controls
Your range is equipped with radiant surface burners with
different wattage ratings. The ability to heat food quicker and in
larger volumes increases as the element wattage increases.
The radiant surface elements are located on the cooktop as
follows:
- a 6 inch radiant element located at the right rear position;
- a 9 / 12 inch dual radiant element located at the right front
position;
- a 7 inch radiant element located at the center rear position;
- Two 7 inch radiant elements located at both the left front
and rear positions. Located between the left front and rear
elements is a Bridge radiant element.
Setting Surface Controls
m lEi lEi
'Kl
V ;tO
O' O,"-
. V- lo V" L I -
..n ft O.. ELtriErn
Note: Please read detailed instructions for ceramic glass
cooktop cleaning in the General Care & Cleaning section
and Before You Call checklist section of this Use and
Care Guide.
Note: Radiant elements have a limiter that allows the
element to cycle on and off to maintain consistent heat
even at the HI setting. This helps to prevent damage to
the ceramic cooktop. Cycling is normal and will occur
even more often if the cookware is too small for the
radiant element or if the cookware bottom is not flat (Refer
to page 7 for instructions on using correct cookware with the
cooktop).
Figure 2
Note: (White glass cooktops only) Due to the high intensity of heat generated by the surface elements, the glass surface will
turn green when the element is first turned off. This phenomenon is normal and the glass will come back to its original white
color after it has completely cooled down.
 CAUTION Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
 CAUTION Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.