Pioneer CT-W505R - Manual (Page 15)

• The tape copying function permits you to copy the contents of a
tape from DECK I to DECK II.
• The SYNCHRO COPY button lets you select 3 types of copying:
copying at normal speed while listening to the song, copying an
entire tape in half the time with high-speed copying, or copying
while reducing noise between songs with TDNS copy.
1. Load a tape for playback into DECK I and a tape for
recording into DECK il.
2. Set the REV MODE switch.
3. Set the tape transport direction.
4. Press the SYNCHRO COPY button to select either
NORMAL, HIGH speed, or TDNS.
• Tape copying is always performed in the direction indicated by
the tape transport indicator (► or ◄). To change this direction,
press the desired playback button (► or ◄), then immediately
press the stop (■) button.
4. Press the SYNCHRO COPY button to select either
NORMAL or HiGH speed or TDNS.
NORMAL : Tape copying atmormafspeed allows you to listen
during playback (COPY indicator lights).
HIGH : Tape copying at double speed (COPY indicator
flashes).
TDNS : Tape copying that reduces noise between songs.
("Tdns" appears on the counter for deck II, or the
COPY indicator flashes.)
NOTES:
• The tape in DECK II will be copied in the same type of the
DOLBY NR (B/C) as DECK Ts tape, regardless of its own set­
ting. When listening to the copied tape, set the type of the
DOLBY NR (B/C) to the type used for recording.
• If a nearby television set is on while high-speed copying is being
performed, a high-pitched interference sound may be heard on
the tape. In this case, either use the normal speed copying func­
tion, or turn off the television.
• During high-speed copying, none of the operation buttons will
function except for the stop (m) button.
• During normal speed copying, the recording mute (O) and pause
(H) buttons of deck II also function.
• Tape copying Is cancelled when either of the two tapes reaches
the end. Therefore it is advisable to use tapes of the same length.
• The sound quality'of the copied tape will be somewhat less than
the original. Therefore when making more than one copy, always
record from the original tape (do not make a copy of a copy).
• The recording level adjustment is not necessary during tape copy­
ing.
• The effect of TDNS copy may not be exhibited well with a tape in
which the noise between musical tunes and musical signal can­
not be distinguished clearly.
In this case, use the NORMAL or HIGH speed copy function.
To stop copying
Press the stop (■) button of either deck. Both decks will stop.
This unit uses non-erasable non-volatile semiconductor memory to
provide semi-permanent (about 10 years) storage of the most recent
AUTO BLE data in addition to the on/off positions of other switches
and buttons. As a result, the most recent settings are stored in the
memory even when the power cord is disconnected.
• BLE data
• FLEX (1/f) System mode (On or off)
• STANDBY ON/OFF
• Tape counter number data
• ALCA data
•
DIRECTION data
To ciear all the memorized data and set the unit to its
original data settings
Press the DECK II recording mute (O) button and DECK I counter
mode (TIME/COUNT) button simultaneously.
15
En