Setting surface controls, Operating the gas surface burners, Setting proper surface burner flame size – Kenmore 790.75604 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Surface Controls
^CAUTION
Do not place plastic
items such as salt and peppershakers,
spoon holders or plastic wrappings
on top of the range when it is in use.
These items could melt or ignite.
Potholders, towels or wood spoons could
catch fire if placed too close to a flame.
In the event of an electrical power outage,
the surface burners can be lit manually.
To light a surface burner, hold a lit match
to the burner head, then slowly turn the
surface control knob to
LITE.
After burner
lights push in and turn knob to desired
setting. Use caution when lighting surface
burners manually.
Setting Surface Controls
Your range may be equipped with different sized surface burners. The ability to
heat food quicker and in larger volumes increases as the burner size increases.
The simmer burner (if equipped) is best used for simmering delicate sauces, etc.
The standard burners can be used for most surface cooking needs.
The Power burners (if equipped) are best used for bringing large quantities of liquid
to temperature and when preparing larger quantities of food.
Regardless of size, always select cookware that is suitable for the amount and
type offood being prepared. Select a burner and flame size appropriate to the pan.
Never allow flames to extend beyond the outer edge of the pan.
operating the Gas Surface Burners:
1
.
2
.
3.
3.
4.
Place cooking utensil on surface burner.
Push the surface control knob in and turn
counterclockwise
out of the OFF
position.
Release the knob and rotate to the LITE position. Note: All four electronic
surface ignitors will spark at the same time. However, only the burneryou are
turning on will ignite.
Visually check that the burner has lit.
Push the control knob in and turn
counterclockwise
to the desired flame
size. The control knobs do not have to be set at a particular setting. Use the
guides and adjust the flame as needed.
DO NOT
cook with the surface control
knob in the LITE position. (The electronic ignitor will continue to spark if the
knob is left in the LITE position.)
Setting Proper Surface Burner Flame Size
For most cooking,
start on the highest control setting and then turn to a lower
one to complete the process. Use the recommendations below as a guide for
determining proper flame size for various types of cooking. The size and type of
utensil used and the amount offood being cooked will influence the setting needed
for cooking.
*Flame Size
Type of Cooking
High Flame
Start most foods; bring water to a boil; pan broiling.
Medium Flame Maintain a slow boil; thicken sauces, gravies; steaming.
Low Flame
Keep foods cooking; poach; stewing.
For deep fat frying,
use a thermometer and adjust the surface control knob
accordingly. If the fat is too cool, the food will absorb the fat and be greasy. If the
fat is too hot, the food will brown so quickly that the center will be undercooked.
Do not attempt to deep fat fry too much food at once as the food will neither brown
nor cook properly.
*These settings are based on using medium-weight metal or aluminum pans with lids. Settings may vary when using
other types of pans.
The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and hardly
visible in a well-lighted room. Each cone of flame should be steady and sharp. Adjust or clean burner if flame is yellow-orange.
Never extend the flame beyond the outer
edge of the utensil. A higherflame simply
wastes heat and energy, and increases
your risk of being burned by the flame.