To set the clock, To set the minute timer, Setting oven controls – Kenmore 790.75604 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Oven Controls
□ sw
I" w ■
yv
I i Í
mm
I SB" I : «g
Note:
The time of day must first be set in order to operate the oven.
To Set the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash "12:00".
1. Press
2. Within 5 seconds, press and hold the ^
or "V
until the correct time of day appears in the display.
Note:
The clock cannot be changed during any timed bake or self-clean cycle.
To Set the Minute Timer:
1. Press ^
2. Press the
^
toincrease the time In one minute increments. Press and hold the ^ to increase the time in 10 minute
increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note:
If you press the v first, the timer will advance to 11 hours and 59 minutes.
3. The display shows the timer count down in minutes until one minute remains. Then the display will count down in seconds.
4. When the set time has run out, the timer will beep 3 times. It will then continue to beep 3 times every 60 seconds until |
is pressed.
Note:
The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is in
use with any otherfu notion, the minute timer will be shown in the display. To view otherfu notions, press the pad for thatfunction.
To Change the Minute Timer while it is in use:
While the timer is active and shows In the display, press and hold the
/v. or 'V'
to increase or decrease the time.
To Cancel the Minute Timer before the set time has run out:
Press
msl.
1 0