Electrode check ~ requires an assistant, Installing cooking components – Kenmore ELITE 141.16681 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Electrode Check ~ Requires an Assistant
Before placing the cooking components into your
grill, ensure that the Spark Electrode Tip is properly
poationed within each Gas Collector Box ( a 4"
vwde stainless mechanism found at the front be
tween each set of Burners.) The easiest way to
enajre this is to perform this Electrode Check:
1. Be sure all Control Knobs are set to
and open the Grill Lid.
"OFF"
2.
Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
3. Press the Ignitor Cap. You should hear a
"clicking" sound and your assistant should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode Tips
are properly positioned.
4. if no spark is seen the Spark Gap shown in
Figure 4 needs to be adjusted as follows:
•
Using an adjustable wrench, loosen the inside
Nut just until the Gas Collector Box can be
maneuvered and turned upward.
•
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
*
if the gap is wider than 3/16" use a pai r of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.
•
Return the Gas Collector Box to its original hori
zontal position, secure the Inside Nut and try the
Electrode Check again.
5. if no "clicking" sound is heard check the following
common causes. If you need assistance caii our
Grill Information Center
at 1-888-317-7642.
*
Ignitor AA battery not installed property.
*
Electric wires may be loose. Remove the AA
battery, inspect the Ignitor Junction Box found
behind the Control Panel, and connect any loose
wires.
Figure 4 - Side View Figure
GAS COLLECTOR BOX
Installing Cooking Components
Important: Before cooking on your grill the first
time, wash the Cooking Grids and Cooking Rack
vwth warni, soapy water. Rinse and dry thoroughly.
After cooking is completed, turn grill to HIGH
setting three to five minutes to bum off rear grease
or food readue.
1. Place the three Stainless Steel Flame Tamers
on the lower ledge above Burners. See Figure 5.
2. Evenly space the Stainless Steel Cooking Grids
(cross braces are bottom side) on the ledge
above the Flame Tamers.
3. Place the Stainless Steel Secondary Cooking
Rack into the slots on the upper left and
upper right of Grill Bowl Side Panels. See
Figure 5.
4. Remove Fastening Band from Pot Support and
place the Pot Support into the Side Burner
Body-Inner. See Figure 5.
Figure 5
S / S
SECONDARY
11