beautypg.com

Figure 13, Figuréis, Figurel – Kenmore 640-82960819-9 User Manual

Page 9: Figure 18, Congratulations

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Important: Before cooking on your grill the first time,

wash cooking grids and cooking rack with warm ,

soapy water. Rinse and dry thoroughly. Season with
cooking oil regularly. After cooking is completed,

turn grill to HIGH setting for 3 to 5 minutes to burn
off excess grease or food residue.

1. Install heat diffusers above burners. Holes in rear

corners of diffusers attach onto pegs in the back
edge of firebox. Ensure that firebox heat shield is

inserted securely into slots between adjacent
burners. If grill was shipped with shield taped in
place, remove tape before using grill.

2. Evenly space cooking grids on the ledge above

heat diffusers. (Fig.14)

3. Insert the legs of the warming rack into the holes

in the tops of the grill bowl side panels. (Fig.14)

4. Insert the side burner grease tray as shown.

(Fig. 15)

Connecting LP gas tank to LP grill

I.Open right door, unlock tank tray lock slip.(Fig.16).

Pull out tank tray, place foot ring of 20 lb tank into

the hole in tray. Make sure the tank valve is on OFF

position. Use the tank bolt to secure the tank in a

fixed position.(Fig.17)

2. Check the tank valve to ensure it has proper

external mating threads to fit the hose and regulator
assembly provided.

3. Make sure all burner valves are in OFF position.

4. Inspect the valve connection port and regulator

assembly. Look for damage or debris. Remove any
debris. Inspect hose for damage. Never use
damaged or plugged equipment.

5. When connecting regulator and hose assembly to

tank valve hand tighten quick coupling nut

clockwise to a full stop. (Fig. 18) Do not use a

wrench to tighten because it could damage the

quick coupling nut and result in a hazardous
condition.

6. Open tank valve fully (counterclockwise). Use a
soapy water solution to check all connections for

ieaks before attempting to light your grill. If a leak is

found, turn tank valve off and do not use your grill

until the leak is repaired.

CAUTION: When the appliance is not in use, gas

must be turned off at the supply tank.

Installing Cooking Components

Figure 13

Figure14

Figuréis

Figuréis

r

Figurel?

e

^ 4

Figure 18

Regulator Connection

Congratulations

Your Kenmore gas grill is now ready for use. Before

the first use and at the beginning of each season

(and whenever the LP gas tank has been changed):

1. Read all safety, lighting and operating

instructions.

2. Check gas valve orifices, burner tubes and

burner ports for any obstructions.

3. Perform gas ieak check according to instructions

found on this page of the manual.