Kenmore 640-82960819-9 - Manual (Page 13)

Then loosen but do not remove the upper two
screws above the light.
7. Pull out the light bulb and replace with a new
bulb. Tighten the four screws.
Note: Do not touch the halogen bulb with bare hands.
8. Replace glass cover, reinsert light bulb housing into
the grill, and insert and tighten the screw.
Cleaning Method
Follow steps 1 through 4 above for glass cover removal. Use a damp towel to clean the surface of the
glass cover. Make sure the glass cover is completely dry before re-installing.
A
WARNING
Make sure the light switch is in the “OFF” position and the power plug is disconnected from the
power outlet prior to cleaning the glass cover.
A
WARNING
The glass cover should not be in contact with water or any other liquid when it’s warm. Sudden
change of temperature may cause cracks in the glass.
A
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
ff you still have questions about replace bulb, call the Customer Service Helpline 8 AM - 5 PM
PST, Monday through Friday at 1-800-913-8999.
13