beautypg.com

Cleaning exterior and attachments, Caution, Motor safety filter changing – Kenmore POWER-MATE 116.24614 User Manual

Page 14: Warning, Electrical shock hazard, Motor safety filter electrostatic

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CLEANING EXTERIOR AND ATTACHMENTS

1. Unplug cord from wall outlet. DO NOT

drip water on cleaner.

2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning.

3. To reduce static electricity and dust build­
up, wipe outer surface of cleaner and

attachments.

A

CAUTION

Do not use attachments if they
are wet. Attachments used in

dirty areas, such as under a

refrigerator, should not be used
on other surfaces until they are

washed. They could leave marks.

MOTOR SAFETY FILTER CHANGING

Check motor safety filter occasionally and
change when dirty.

A

WARNING

Electrical Shock Hazard

Unplug power cord from electrical
outlet. Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical shock.

Remove the bag as outlined in the BAG
CHANGING section.

MOTOR SAFETY FILTER
ELECTROSTATIC

This while filter must be replaced when

dirty. It should be replaced regularly
depending on use conditions.

The filter

CANNOT be washed as it will lose its
dust trapping ability.

NOTE:

See PARTS AND FEATURES for

motor safety fitter number.

1. Lift the rubber
retainer and pull
out motor safety

filter as shown.

2. Replace the fil­
ter,

white side out,

facing the dust bag,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com­
pletely under the

rubber retainer.

3. Replace the bag as outlined in the BAG
CHANGING section.

14