Kenmore 99721 - Manual (Page 28)

CARE AND CLEANING
Wipe the microwave inside and out with a mild detergent solution, rinse, and wipe di^ This should be
done on a weekly basis-more often if needed. Neuer use rough powders or pads.
REMOVABLE PARTS
I After each use of the Temperature Probe, it must be removed from the socket. Use pot holder, as the wire,
plug and sensor sections may be hot. Wipe food or liquid from sensor with damp cloth.
■ The glass tray and metal rack can be removed for cleaning at the sink. Wipe up spillovers with paper towel
or doth before removal of tray,
■ The oven inside top (stirrer shield) can be gently wiped in place or removed for washing at the sink.
It rests in slots along the sides and in the rear of the oven and is held by two tabs in front
Pull the front edge down and forward to remove. Wash only in warm (not hot) detergent water rinse and
wipe dry. Avoid hitting or bending the metal stirrer blades, as this could cause uneven cooking or damage
to the oven.
To replace shield, slide it into the side and rear slots with cut-off at left rear corner, and fit the front edge of
the shield with the two tabs.
H Wash in warm soapy water and dry.
Do not use rough cleaning "powders, steel wool, or rough cleaning pads.
SPECIAL CARE
For best performance and safety, the inner door panel and oven front frame should be free of food or grease
buildup. Wipe both often with a mild detergent, rinse, and wipe dry. Neuer use rough powders or pads.
ter cleaning the control panel, touch CLEAR. This will clear any entries that might have been entered
accidentally while cleaning the panel.
28