Before you cali, Solutions to common problems), Occurrence possible cause/solution – Kenmore 790.3107 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are
not the result of defective workmanship or materials in this appliance.
Before You Cali
(Solutions to Common Problems)
OCCURRENCE
POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and
Electronic control has detected
a
fault condition. Press STOP to clear the display and
Displays any F code error
stop the beeping. Reprogram the oven. If a fault reoccurs, record the fault number. Press
(example Fll).
STOP and call Sears or another qualified servicer.
“d-O” is displayed.
The door was left open and controls set for self-cleaning cycle. Close the door and push
STOP pad.
Faulty installation.
Place oven rack in center of oven.
Range not leveled.
Place
a
level or
a
marked glass measuring cup filled with water on the center of the
Bad cooking results.
oven rack.
If the water level is uneven, adjust the leveling legs of the unit (refer to the installation
instructions for leveling the range).
If the level is still uneven, contact an installing agent to adjust the cabinet cutout
flooring.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
Surface burners do not light.
Surface control knob has not been completely turned to LITE. Push in and turn the
surface control knob to LITE until burner ignites and then turn the surface control knob
to the desired flame size.
Burner ports are clogged. Clean burners. See “Cleaning the Burner Grates, Burner Caps
and Burner Heads” under General Cleaning.
Range power is disconnected from outlet. Be sure cord is securely plugged into the
outlet.
Electrical power outage.
Be sure the gas supply to the range is turned “ON”.
Surface burner flame burns half
Burner ports or slots are clogged. With the burner off, use
a
small-gauge wire or needle
way around.
to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to operate
until flame is full. Dry the burners thoroughly following instructions under General Cleaning.
Surface burner flame is orange.
Dust particles in main line. Allow the burner to operate
a
few minutes until flame turns
blue.
Salt air in coastal areas. A slightly orange flame is unavoidable.
Fan noise during cooking
A cooling fan may automatically turn on and off to cool internal parts. This is normal.
operation.
and the fan may continue to run even after oven is turned off.
Entire oven does not operate.
When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The oven cannot be programmed until the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact
Sears or another qualified servicer.
Service wiring not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls to set the
controls.
House fuse has blown or circuit breaker has tripped immediately following installation.
House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker
securely.
House fuse has blown or circuit breaker has tripped after the oven has been installed
and previously operating. Call Sears or another qualified servicer.
37