Setting the dual ring burner, Setting surface controls, Large cookware operation (figure 1; zone a & b) – Kenmore 790.3107 User Manual
Page 13: Simmering operation (figure 1; zone a)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
w
Figure 2
Setting the Dual Ring Burner
The Dual Ring Burner has two rings of flame that you can
control for two different heat levels, one for small and one
for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1.
Place
a
large cooking
utensil centered over
the dual surface Burner
■
Grate.
2.
Push the surface control
knob down and turn
counterclockwise out of
the OFF position.
3.
Release the knob and
rotate to the LITE
position (Figures 2 & 3).
4.
Visually check that the
burner has lit.
5.
When the burner is lit,
continue to turn the
control knob counterclockwise between the HI position
and the MED position to adjust to the desired flame
size for both burners together (Figure 1).
Simmering Operation (Figure 1; Zone A)
1.
Place a small cooking utensil centered over the dual
surface Burner Grate.
2.
Push the surface control knob in and turn
counterclockwise out of the OFF position (Fig. 2 & 3).
3.
Release the knob and rotate to the LITE position.
4.
Visually check that zone A & В of dual burner has lit.
5.
Continue to turn the gas control knob counterclockwise
past the MED position; zone В will turn off. Adjust the
simmer flame size by turning the control knob between
the MED position to the LO position.
Important notes:
•
DO NOT cook with the surface control knob left in the
LITE position. (The electronic ignitor will continue to spark
if the control knob setting remains in the LITE position).
•
When setting any surface control knob to the LITE
position, all electronic surface ignitors will spark at the
same time. However, only the surface burner you are
setting will ignite.
•
NEVER pi ace or straddle
a
cooking utensil over two
different surface cooking areas at the same time. This
can cause uneven heating results.
Setting Surface Controls
DUAL RING BURNER
OFF
LITE
Figure 3
к
13