beautypg.com

Care & cleaning, Removing and replacing the oven door, To remove oven door – Kenmore 790.3107 User Manual

Page 34: To replace oven door

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Care & Cleaning

Removing and Replacing the Oven Door

ià CAUTION

j The oven door is heavy. Be careful when

removing and lifting the door. Do not lift the oven door by

the handle.

Most oven doors contain glass that can

break. Read the following recommendations:

• Do not close the oven door until all the interior oven racks

are fully inserted and retracted to the back of the oven.

• Do not hit the glass with pots, pans, or any other object.

The oven door glass may break or even break at

a

later

time unexpectedly.

• Scratching, hitting, jarring or stressing the oven door glass

may weaken its structure causing an increased risk of

breakage at

a

later time.

• You may use a glass cleaner on the outside of the oven

door glass. Do not spray or allow water or the cleaner to

enter or drip down into the oven door vents. Spray cleaner

on cloth first and then wipe the oven door clean.

• Do not use strong oven cleaners, powders or any harsh

abrasive cleaning materials on the outside of the oven

door or glass.

• Never clean the oven door gasket. The oven door gasket

should always clean during the Self-clean cycle.

To Remove Oven Door:

1.

Open oven door completely (horizontal with floor - See

Figure 1j.

2.

Pull the door hinge locks on both left and right door

hinges down from the oven frame completely towards

the oven door (See Figure 2). A tool such as

a

small fiat­

blade screwdriver may be required.

3.

Firmly grasp both sides of oven door along the door sides

(Do not use the oven door handle - See Figure 3).

4.

Close the door to the broil stop position (the oven door

will stop into this position just before fully closing).

5.

With the oven door in the broil stop position, lift the

oven door hinge arms over the roller pins located on

each side of the oven frame (See Figure 4).

To Replace Oven Door:

1.

Firmly grasp both sides of oven door along the door sides

(Do not use the oven door handle - See Figure 3).

2.

Holding the oven door at the same angle as the removal

position, seat the hook of the hinge arm onto the roller

pins located on each side of the oven door frame (See

Fig. 4). Also, seat the notch of the hinge arm onto the

bottom of the slot at the same time you seat the hook.

The hook and notch of the hinge arms must be fully

seated onto the roller pins and bottom of the slot.

3.

Fully open the oven door (horizontal with floor - See

Figure 1).

4.

Push the door hinge locks up towards and into the oven

frame on both left and right oven door hinges (See

Figure 2) to the locked position.

5.

Close the oven door.

Figure 2

Roller pin

Hinge arm hook

• Hinge arm notch

Slot bottom

34

Figure 4

This manual is related to the following products: