beautypg.com

Setting the bridge burner, Operating the bridge burner, Setting surface controls – Kenmore 790.3107 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Setting the Bridge Burner

The Bridge Burner should be used with rectangular shaped

cookware. Cookware like

a

cast-iron Griddle is designed

specifically for best results with the Bridge Burner.

The Bridge Burner feature may be used to combine the

cooking power of 2 or if needed 3 gas surface Burners

located along the left-hand side of the cooktop. The left

rear and left center Burners are controlled by the left rear

surface Control Knob. In addition the left front Burner may

be added to the Bridge Burner with the left front gas Control

Knob.

Operating the Bridge Burner

1.

Push the left rear surface

control knob in and turn

counterclockwise out of

the OFF position (See

Figure 1).

2.

Release the knob and

rotate to the LITE

position.

3.

Visually check that the

left rear Burner has lit.

4.

Continue to rotate

the gas control knob

counterclockwise to the

"HI bridge” position

Figure 1

(Figure 2).

Setting Surface Controls

5.

6

.

Visually check that both the left rear and left center

Burners are lit.

When both burners are lit, continue to turn the control

knob counterclockwise to adjust to the desired flame

size for both burners together.

Note: The markings between the “HI bridge” and the “LO

bridge” settings adjust the flame size for both burners.

7. Add the left front Burner if needed. Once lit, visually

adjust the flame size of the left front burner to match

the flame size of the bridge burner.

Important notes:

DO NOT cook with any of the surface control knobs in

the LITE position (The electronic ignitor will continue to

spark if the knob is left in the LITE position).

When setting any surface control knob to the LITE

position, all electronic surface ignitors will spark at the

same time. However, only the surface burner you are

setting will ignite.

If only the left rear surface Burner is needed, adjust the

settings between the 1st HI and LO.

The left front Burner may be added to the Bridge Burner

by setting the left front gas Control Knob.

BRIDGE BURNER

OFF

LITE

Figure 2 - Bridge Burner

12

This manual is related to the following products: