Kenmore 790.9911. - Manual (Page 36)

General Care & Cleaning
FEATURE OVERVIEW
• Removing & Replacing Warmer Drawer
Oven Lights
FEATURE OVERVIEW
• Operating Oven Lights
• Replacing Oven Light
To Remove and Replace Warmer {Warm & Ready™) Drawer
To Remove Warmer Drawer:
^CAUTION Turn power off before removing the warmer drawer.
2. Open the drawer to the fuiiy opened position.
3. On the right glide you will find a shield attached with a hex-head screw
(See Fig 1). Using a 1/4” socket and ratchet remove the shield.
4. Locate glide lever on each side of drawer, puli up on the left glide lever
and push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1
.
2
.
3.
4.
Replace shield on the right glide of the drawer body.
Puli the bearing glides to the front of the chassis glide (See Fig. 2).
Align the glide on each side of the drawer with the glide slots on the
range.
Push the drawer into the range until levers “click” (approximately 2”).
Pull the drawer open again to seat bearing glides into position. If you do
not hear the levers “click” or the bearing glides do not feel seated
remove the drawer and repeat steps 2-4. This will minimize possible
damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while
Lockout” modes
ikWARNING Electrical Shock Hazard can occur and result
In serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
iiCAUTION Be sure the range is unplugged and all parts are
COOL before replacing oven light(s). Wear a leather-faced glove for
protection against possible broken glass.
To Operate the Oven Lights
Both of the interior oven lights automatically turn on when the oven
door is opened. Press to turn the lights ON and OFF when the
oven door is closed. Each oven light is located at the rear wail of the
oven interior and is covered with a glass shield held by a wire holder
(See Fig. 3). The Glass Shields must be in place whenever the oven
is in use.
To Replace the Oven Light(s):
1. Turn electrical power off at the main source and unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace the old bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source & plug in the
range.
6 . The clock will then need to be reset. To reset, see Setting the
Clock in this Use & Care Guide.