Feature overview, Operating the warmer drawer, Surface cooking – Kenmore 790.9911. User Manual
Page 13: Setting warmer drawer controls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Fig.1
FEATURE OVERVIEW
^
• Using the Proper Cookware
Cookware should have flat bottoms
that make good contact with the entire
surface heating element. Check for
flatness by rotating a ruler across the
bottom of the cookware (See Fig.1).
Be sure to follow ail the
y
recommendations for using cookware
as shown in Fig. 2.
Note:
The size and type of cookware used will influence the
setting needed for best cooking results.
Deep fat frying
- Use a thermometer and adjust the surface
control accordingly, if the fat is too cool, the food will absorb
the fat and be greasy. If the fat is too hot, the food will
brown so quickly that the center will be undercooked. Do not
attempt to deep fat fry too much food at once as the food
wiii neither brown nor cook properly.
Surface Cooking
.
CORRECT
INCORRECT
>
Flat bottom and straight
sides.
I Tight fitting lids.
>
Weight of handle does not
tilt pan. Pan is well
balanced.
>
Pan sizes match the
amount of food to be
prepared and the size of
the surface element.
' Made of a material that
conducts heat well.
' Easy to clean.
' Always match pot diameter
to element surface
diameter.
Fig. 2
' Curved and warped pan
bottoms.
Pan overhangs element by
more than one-half inch.
' Pan is smaller than
element.
Heavy handle tilts pan.
m
Æoa/:
".iC
Setting Warmer
Drawer Controls
p
^
ature
overview
•
Arranging Warmer Drawer
Racks
•
Operating & Setting Warmer
Drawer Controls
Arranging Warmer (Warm & Ready™) Drawer Rack Positions
The rack can be used in two ways:
•
In the
upward position
{Fig. 3) to allow low profile food items to be placed
both under and on top of the rack {for example, roils or biscuits on top of the
rack and a casserole dish underneath).
•
In the
downward position
{Fig. 4) to allow you to place light weight food
items and empty dishware {for example, rolls or pastries and dinner plates)
on the rack.
Operating the Warmer Drawer
The purpose of the Warmer Drawer is to keep hot cooked foods at serving
temperature. Always start with hot food. It is not recommended to heat coid
food in the Warmer Drawer. Ail food placed in the Warmer Drawer should be
covered with a lid or aluminum foil to maintain quality.
Do not use plastic
wrap to cover food. Plastic may melt onto the drawer and be very difficult
to clean.
Use only utensils and cookware recommended for oven use in the
Warmer Drawer.
A
caution
Always use potholders or oven mitts when removing food
from the Warmer Drawer as cookware and plates wili be hot and you can be
burned.
WarmerDrawer Recommended Food
SettingsTable
Food Item
Setting
Bacon
HI
Hamburger Patties
HI
Poultry
HI
Pork Chops
HI
Fried Foods
HI
Pizza
HI
Gravies
MED
Casseroles
MED
Eggs
MED
Roasts {Beef, Pork, Lamb)
MED
Vegetables
MED
Biscuits
MED
Roiis, hard
MED
Pastries
MED
Roils {soft)
LC
Empty Dinner Plates
LC
Fig. 5
13