Kenmore 790.9911. - Manual (Page 17)

Setting the Clock
FEATURE OVERVIEW
• Setting the Ciock
• Changing between 12 or
24 hour display
S tart
T imed O ven
O ven C ook S tart
T ime T ime
C lean
OVEN
light
O w O ff
SERVE
WARM
KilfeHEN
s/íHKÍIIÍ'j
illiiiii:
88:88 IMl 888
TIMED DELAY TIMER n CONV BAKE BROIL
DOOR LOCKED CLEAN Q MEATS CAKES BREADS
b XÍ e , HKT:
MEATS £ C akes breads
... lilÉiiiÉiliiiii
Setting the Clock
The CLOCK pad is used to set the clock. The ciock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with "PF" (power
failure, See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
PRESS
1. Press "CLO" will appear in the display (Fig. 2). (C lo ^
2. Press ^ ©C l )®
(Fig. 3). "CLO" will appear in the display. Press .
"CLO" will disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold for 6 seconds (Fig. 3). While holding
the pad down the current time of day will remain and "CLO"
will disappear from the display (Fig. 4). CONTINUE holding
the pad until a beep is heard.
2. The display will show either "12Hr"(Fig. 5) or "24Hr"(Fig. 6).
3. Press to switch between the 12 and 24 hour time of
day display. The display will show either "12Hr" (Fig. 5) or
"24Hr" (Fig. 6).
4. Press to accept the desired change or press to
reject the change.
5. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
C lock )
for 6 seconds
Q|-
M
Wltm
8 iilli
ll;|i C lock | 0
IflrOFfli
;j;Í|ÍLEAlj|||
lг:oo
Fig.l
DISPLAY
t e o o C L O
m
“Sf
".iC
Fig. 2
Fig.3
Fig. 4
líHr
Fig. 5
гw
Hr
Fig. 6
17