Kenmore 625.34846 - Manual (Page 6)

SECTION 1
WATER SOFTENER START-UP
PROGRAM THE TIMER
FIG. 1
When the transformer is plugged in, the model
code SC21 shows in the face plate display for a
few seconds, followed by a test number (exam­
ple; S4.0). After the test number, 12:00 AM
begins to flash. PRESENT TIME and RE­
CHARGE TONIGHT show at the bottom of the
display.
CODE
^ 4
«te ^ «
• *• *
PRESENT TTME
NOTE;
1. SET PRESENT TIME OF DAY:
NOTE:
If the words...PRESENT TIME do not show in
the display, press the SELECT button (FIG.
1) until they do.
■ Press the 0UP/DOWN Qbuttons to set the
present time. Press UP to move the display
ahead; press DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
if SC — flashes in the di^iay, press the UP 0
button (FIG. 1) until SC21 does show. Then
press the SELECT button to display the flashing
12:00 AM. IF OTHER THAN SC21 SHOWS
when the transformer is plugged in, please see NOTE:
page i / to reset. ^
If the present time is between
midnight and noon, be sure AM
shows.
■■ *
•*
ggwmii-
SOUND “BEEPER”; A "beeper” sounds while
pressing buttons for timer set-up. One beep
signals a change in the face plate display.
Repeated beeps means the timer will not accept
a <^ange from the button you have pressed,
telling you to use anotiier bi^on. For example,
while setting the hardness (step 2), the beeper
sounds repeatedly when the display reaches 1
using the DOWN button, or the highest hardness
setting using the UP button.
Each press of the UP/DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
6