Kenmore 625.34846 - Manual (Page 21)

SECTION 5
SERVICER’S TECH. INFORMATION
5A. TROUBLESHOOTING
CORRECT
SWITCH
DISPLAYS VALVE CYCLE STATUS
—
Valve in service, fill, brining,
backwash or fast rince position
-P
Valve rotating from one posi­
tion to another
C. While in this diagnostic screen, the following
information is availabie and may be benefi­
cial for various reasons. This information is
retained by the computer from the first time
eiectrical power is applied to the face plate.
... Press 0to dispiay the number of days this
face plate has had eiectricai power applied.
... Press ©0 dispiay the number of regenera­
tions initiated by this face plate since the SR
code number was entered.
2. Press Seiect to advance to the foliowing
alternating displays.
CL E Rn
This setting controls the length of the back­
wash cycle (regular recharge backwash, and
the CLEAN feature backwash if set to ON). A
ionger backws^h is beneficial if suppiy water
is dirty, or contains iron. The time is adjust­
able up to 5 minutes. Use the UP or DOWN
button to set
3. The next press of the SELECT button dis­
plays an AUTO RECHARGE screen. Ru
KCHAROE
For this model, the AUTO RECHARGE dis­
play must show. If anything other than AUTO
shows, press a UP or DOWN button until it
does show.
4.
Press SELECT cxice again to display 12 hr, TIME.
Ttm
iS hr hr
TJMË
At this setting, dispiay times are shown in
standard clock time, if set to 24 hr, using the
UP or DOWN button, dispiay times wiil be in
miiitary time, 0100 (1:00 AM) to 0000 (mid­
night).
5. Press the SELECT button and hoid 3 se­
conds until...
.SC21 shows.
COM
H'
This code identifies the softener nominai capac­
ity size. If the wrong number shows, the softener
will operate on incorrect programming. Do the
foliowing as needed.
RETURN THE PRESENT TIME DISPLAY- press
the SELECT button.
CHANGE THE SR NUMBER - press the UP or
DOWN button to display correct numben press
SELECT, and reset the timer.
NOTE
If the face iXate is left in a diagnostic dispiay (or a flashing
display when setting times or hardness), present time
automatically returns if a button is not pres^ within 4
minutes.
21