Kenmore 625.34846 - Manual (Page 12)

SECTION 2
HOW YOUR WATER SOFTENER WORKS
2B. SOFT WATER SERVICE AND REGENERATION
HJBRINING: During brining, the brine is moved
from the salt storage area, into the resin tank.
Inside the resin tank, brine cleans hardness
minerals from the resin beads and they are
discharged out the drain. How much brine is
needed to clean the resin depends on...
...№e amount of resin in the softener,
...how fast the brine goes through the bed.
The nozzle and venturi (FIG. 6) make suction to
take brine from the salt tank and put it into №e
resin tank. It keeF>s the brine flow down to a very
slow rate to get the best resin cleaning with the
least salt
mBRINE RINSE: After ail of the brine goes into
the resin tank, the brine valve closes. Water
keeps flowing №e same way it did during brining
except the brine flow has stopped. Hardness
minerals and brine flush from the resin tank to the
drain. Brining and brine rinse together vary in
length relative to the fill cycle length.
FIG. 7
FIG. 6 WATER FLOW THROUGH THE
SOFTENER IN BRINING AND
BRINE RINSE
Hard Water
IN
mBACKWASH: During backwash, water flows
UP through the resin tank (FIG. 7) at a fast rate to
flush iron minerals, dirt and sediments from the
bed and to the drain. The bed lifts and expands
for good cleaning.
WATER FLOW THROUGH THE
SOFTENER IN BACKWASH
Hard Water
bypass
resin bed
and expa
OFAST RINSE: Backwash is followed by a fast
flow of water down through the resin tank. The
fast flow pad
return to service (FIG. 8).
After fast rinse, the softener returns to service.
Hard water goes into the resin tank where the
resin bed again takes out the hardness minerals.
Soft water goes to №e house soft water pipes.
FIG. 8 WATER FLOW THROUGH THE
SOFTENER IN FAST RINSE
Soil Water
OUT
12