Kenmore 625.34846 - Manual (Page 19)

SECTION 5
SERVICER’S TECH. INFORMATION
5A. TROUBLESHOOTING
KEEP THIS MANUAL WITH YOUR WATER SOFTENER. IF REPAIRS ARE NEEDED. THE SERVICE
TECHNICIAN MUST HAVE THE INFORMATION ON THE FOLLOWING PAGES.
(RECHARGE TONIGHT ~ NOVQ
ALWAYS MAKE THESE INITIAL CHECKS RRST
1. Does the time display show the correct time of day?
...If display is blank, check power source to the
softener.
...If time is flashing, power was off for over 6 hours.
The softener resumes normal operation but regen­
erations occur at the wrong flme.
...If EinfflTor code (Example; Err 03) shows in the face
plate display, go to AUTOMATIC ELECTRONIC
DIAGNOSTICS.
Plunfl}ing bypass valve(s) must be in Full Service
position. 2
.
3.
4.
The inlet and outlet pip^ must connect to tire soft^er
Inlet and outlet respectiveiy.
Is the transformer plugged into a liv^, grounded wall
outlet, and the pow^ <^e fastened securely?
5. The valve drain hose must be free of kinks and sharp
bends, and not elevated over 8 ft above the floor.
REMOVE THE TOP COVER AND SALT TANK COVER
6. is there salt in the storage tank?
7. Is the brine tubing connected? {See water flow
digrams).
8. Is the brine valve float set right? (See page 22).
9. Press the SELECT button 2 times to dsplay the
hardness setting. Be sure it is the correct setting forthe
househokfs water supply. (Make a hardness test of the
raw water and compare w№ the hardness setting. Also
test a soft wat^ sample to verify if a problOT) exists.)
Press SELECT 3 times to return the present time
display.
If you do not And the pixdtiem aft^ making irfltiai checks, do
the MANUAL INITIATED ELECTRONIC DIAGNOSTICS.
and the MANUAL ADVANCE REGENERATION CHECK.
19