beautypg.com

Releasing the handle, Handle mounted, Pile height selection and setting – Kenmore 116.31913 User Manual

Page 7: Caution, On/off swit handle mounted, Some models

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

RELEASING THE HANDLE

Release the handle by pressing down on

the handle release pedal with your foot and

pulling back and down on the handle with

your hand,

Note:

The agitator will not rotate if the vacu­

um cleaner is in the upright position.

ON/OFF SWIT

HANDLE MOUNTED

SOME MODELS

To start the vacuum cleaner, slide the
On/Off switch from the OFF position to the

ON position. To stop the vacuum cleaner,
slide the On/Off switch to the OFF position.

Note:

This switch operates the suction

motor only. For the agitator to rotate, the
agitator On/Off selector must be in the ON
position and the handle must be released

from the upright position.

PILE HEIGHT SELECTION AND SETTING

To select a pile height setting:

Turn off cleaner. Select a pile height setting

by tilting the cleaner back until front wheels

are lifted slightly off the floor.

Slide the adjustment lever to the correct set­

ting.

There are four (4) pile height settings on the
vacuum. Use the LOW setting for most car­

pets and bare floor cleaning (with agitator
OFF), and the

HIGH

setting for very long

pile carpets like shag carpet, scatter rugs,

etc. Use the other settings as needed for

carpet heights in-between,

Height

Adjustment

Lever

A

CAUTION

Do not allow vacuum cleaner to
remain In one spot for any length of

time when the agitator is turning.

Damage to carpet may occur.

This manual is related to the following products: