Kenmore 116.31913 - Manual (Page 16)

FILTER CHANGING
Check motor safety fiiter frequently and
change when dirty
HTtV ......... ......... ...
f V % WAR WARMING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
Installed to prevent motor failure
and/or electrical shock.
Motor
Safety
Filter
Remove the dust bag as outlined in the
DUST BAG CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
1. This white & grey
filter must be
replaced when dirty
It should be replaced
regularly depending
on use conditions.
The filter CANNOT
be washed as it will
lose its dust trap­
ping ability.
Note: See PARTS AND FEATURES for
motor safety filter number.
2. If the filter, locat­
ed in the bottom of
the bag cavity is
dirty remove it by
pulling forward out
from under the
ribs.
3. Replace the
filter, white side
up, by sliding it
back into place
under the ribs in
the bag cavity
Motor
Safety jKA
Filter—
Motor
Safety
Filter
Replace the bag as outlined in the DUST
BAG CHANGING section.
EXHAUST FILTER
HEPA
A
WARNING
Do not operate without exhaust
filter.
The exhaust filter cartridge must be
replaced when dirty. It should be replaced
regularly depending on use conditions. The
filter CANNOT be washed as it will lose
its dust trapping ability.
Note: See PARTS AND FEATURES for the
exhaust fiiter number.
Slide the exhaust
fiiter cover
release down.
Pull out on
exhaust filter
cover to remove
from bag cover.
Bag
Cover—*t
Sag
Cover
Exhaust Filter
Cover Release
Exhaust
Filter
Replace the exhaust
filter cartridge, care­
fully positioning it so
that it fits into the bag
cover.
The grey edge
of the filter should
be facing away from
the operator.
Push
only on filter cartridge
frame, not on filter itself.
Exhaust Fiiter
Cover Release
Exhaust
Filter Cover
Exhaust
Filter Cover
Remove the
exhaust filter car­
tridge from the bag
cover.
Bag
Cover
Replace the
exhaust fiiter
cover and
secure the
latch by push­
ing it upward.
(e