beautypg.com

Dust bag changin, Warning, 1 caution – Kenmore 116.31913 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

DUST BAG CHANGIN

TO REMOVE DUST BAG

WARNING

Always unplug power cord from
electrical outlet before performing
any service on vacuum.

Pyli out on the
bag cover release
located near the

top of the bag
cover

Bag Cover

BeieasB

Bag

Bag
Cover

Grasp the dust bag
collar and pull gently
carefully removing
the dust bag.

Throw away the used

dust bag.

Do not reuse.

Pull the bag

cover forward
and lift up

Remove and lay

aside

mi I

Bag Holder

Bag Cavity

Motor
Safety

filter

Dmt

Bag

Check the bag
holder and the
motor safety fil­
ter. If either is
blocked, check

TOr^l IDI C

I irv/UK/Lrw“

SHOOTING.

!1 CAUTION

NEVER REUSE A DUST BAG. Very

tine materiais, such as carpet fresh­

ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu­
uming these materials.

TO REPLACE DUST BAG

Dust
Bag

Safety
Seal Tab

Unfold the new

dust bag. Fold
the safety seal
tab on the new

dust bag away

from the open

ing that fits on

the bag holder.

NOTE: See PARTS AND FEATURES for
bag number

Insert the dust bag
onto the bag holder
completely by holding

the bag collar

Place the dust bag
collar into position.

Tuck the bag

behind each of the

four bag retention

corner flaps shown
here. Be sure the
bottom and sides
of the dust bag are
compietely within
bag cavity prior to

replacing the bag
cover.

Bog
Retention

Corner

Flaps

Position the bag

cover so its posi­
tioning tabs fit
into the body
positioning tab
slots.

Close the bag
cover.

You will hear a
distinct snap
when cover is
securely closed.

Bag
Cover

Check to see that the dust bag is fully
enclosed in the bag cover.

ПФ

This manual is related to the following products: