Warning, Caution, Agitator cleaning – Kenmore 116.31913 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LIGHT BULB CHANGING
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit
Failure to do so could result in elec
trical shock or persona! injury from
cleaner suddenly starting.
TO REiyiOVE LIGHT BULB
Disconnect power cord from electrical out
let.
Pty light lens
out at slot In
rear as shown
on both sides.
Rotate lens up
and lift off
CAUTION
Do not use a bulb rated over ISWatt
(130Volt). During extended use, heat
from the buib could overheat sur
rounding plastic parts.
Remove the
light bulb by
pushing the
bulb in while
turning coun
terclockwise to
release from
the slotThen
pull the light
buib straight
out
To replace the
light bulb care
fully Insert and
turn clockwise
to securely fit
into slot.
Note: See PARTS AND FEATURES for bulb
number
A
CAUTION
Do not plug In or turn on until the
vacuum is completely reassembled.
To replace light
lens, place tabs
at front of lens
into stols- Rotate
lens down and
snap into place
Light
Lens ^ ^
AGITATOR CLEANING
To maintain efficient cleaning, the agitator
must be kept free of carpel pile, string, or
hair build-up. After every 7 to 10 uses,
unplug and turn vacuum over and check
agitator for string and hair buiirf-up
Use a scissors to remove any build-up
entangled around the agitator,
17