Kenmore 790.9446 - Manual (Page 38)

General Care & Cleaning
• Changing the Oven Light
Changing the Oven Light
The oven light automatically turns ON when the door is opened. The oven light
may also be manually operated by pressing the (?) pad.
The oven light bulb is located at the rear of the oven and is covered with a glass
shield held by a wire holder. The glass shield must be in place whenever the
oven is in use.
To replace the oven light bulb:
1 .
2
.
3.
4.
5.
6
.
Turn electrical power off at the main source or unplug the range.
Press wire holder to one side to release the glass shield.
Replace bulb with a new40 watt appliance bulb.
Replace glass shield over bulb and snap wire holder into place.
Turn power back on again at the main source (or plug the range back in).
The clock will then need to be reset. To reset, see
Setting the Clock and
Minute Timer in this Use & Care Guide.
ikCAUTION Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass.
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.
38