Kenmore 3950145 - Manual (Page 35)

Problem Possible Cause Solution
Machine
Stops Power cord not plugged in. Plug in power cord.
No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit
breaker open. Repiace fuse or reset circuit breaker.
If problem continues, call electrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turn timer to the right slightly
and pull to start.
Timer knob not pulled out. Set and pull out knob.
Washer at pause in
PERMANENT PRESS Cycle
(approximately two minutes).
Allow cycle to continue
(see “OPERATION”).
Machine is overloaded. Wash smaller loads.
Agitator Not
Working The top of the agitator moves
only in one direction. This is normal.
The top of the agitator is loose. This is normal.
Water Levei
Too Low/Not
Completely
Filling
The top of the agitator is much
higher than the highest water
levei. This creates a perception
of the washer not being full.
This is normal.
Tub is
Crooked Tub pulled forward when
unloading.
Ensure tub is centered before
starting washer.
Tub moves. This is normal.
Unit not level. Ensure front feet are installed and
nuts are tightened. Level washer.
Reset rear legs (see “INSTALLATION,”
Section G).
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
Overloading. Lint can be trapped in load if
overloaded. Wash smaller loads.
Paper or tissue in pockets. Clean out pockets before washing.
Not enough detergent. Use enough detergent to
hold tint in water.
Detergent not dissolving.
Water temperatures lower
than 60“F.
Use Automatic Temperature Control
(АТС), if available. АТС ensures wash
water temperature will be warmer than
70“F.
35