Kenmore 116.27514 - Manual (Page 8)

CANISTER
1. Open the canister hood,
2- Check to see that the dust bag is proper­
ly instated. See BAG CHANGING for
instructions.
3. Check to see that the motor safety filter is
properly installed See MOTOR SAFETY
FILTER CHANGING for instructions.
HOOD AND TOOL
STORAGE COVER
It is normal for the canister hood and tool
storage cover to come off when opened fur­
ther than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and tool storage cover to reinstall.
A caution
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canister hood and/or tool storage cover.
HOSE
1. Line up the hose
latch fab and notch
in canister hood
and insert hose
into canister until It
snaps in place.
To remove: Lift
hose latch tab
upward and pull
on hose.
up
2. Insert han­
dle into wand
until lock but­
ton snaps in
place. Be
sure hose Is
not twisted.
To remove:
Press handle
quick release
button and
puil up on
handle,
To store: Disconnect hose from wands and
canister to prevent stress on hose during
storage. Store hose in a loosely coiled
position so the hose covering is not
stressed.
PET POWERWIATE STORAGE
This canister is equipped with an on-board
storage area for a Pet PowerMate attach­
ment
To Install;
Open the Pet PowerMate storage cover.
Insert the Pet PowerMate, press down into
place, and dose the lid securely
To Remove:
Open the storage cover Remove Pet
PowerMate from the storage area and use
as needed (see ATTACHMENTS and
ATTACHMENT USE TABLE).
Pe( PowerMatB
Storage Cover