Kenmore 116.27514 - Manual (Page 15)

CLEANING EXTERIOR AND ATTACHÍVÍENTS
1, Unplug cord from wat! outlet DO NOT
drip water on vacuum cleaner.
2, Clean exterior using a dean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry
Wipe dry after cleaning.
3, To reduce static electricity and dust build­
up, wipe outer surface of vacuum cleaner
and attachments.
A
CAUTION
Do not use attachments if they are wet
Attachments used In dirty areas, such
as under a refrigerator, should not be
used on other surfaces until they are
washed.They could leave marks.
'■.'lyj'
r<7
v«*V* . .
ir: I
MOTOR SAFETY FILTER CHANGING
j
A WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the motor safety filter.
Be sure the filter is dry and properly
installed to prevent motor failure and/or
electrical shock.
MOTOR SAFETY FILTER
ELECTROSTATIC
This filter must be replaced when dirty, it
should be replaced regularly depending on
use conditions. The filter CANNOT be
washed as It will lose its dust trapping
ability.
NOTE: See PARTS AND FEATURES for
Motor Safety Filter number
1, Remove the bag as outlined in the
BAG CHANGING section.
2. Lift the rubber
retainer and pull
out motor safety
filter as shown.
3. Replace the filter,
white side out,
facing the dust bag,
by sliding it back into
place under the ribs
in the bag cavity.
Tuck filter in so that it
fits compietely under
the rubber retainer.
4. Replace the bag as outlined in the BAG
CHANGING section
15