To replace belt, Light bulb changing, Note: see parts and features for – Kenmore 116.27514 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TO REPLACE BELT

1. install new
belt over
motor drive,

then over
belt path

NOTE: See
PARTS AND
FEATURES

for Belt number.

Motor
DrlVB

Sort
Path

Agitator End Cap

Place agitator

assembly back into
PowerMate.

3. Line up
front of
cover and

base, Rest

cover on
front edge
of base as
shown.

side

Latch

Rear

Latches

4. Rotate cover

back. Press

cover firmly until
side and rear

latches snap
into place.

Make sure there

is no gap between the cover and base

5. Turn PowerMate upside down and
replace two (2) cover screws.

LIGHT BULB CHANGING

1. Remove PowerMate cover as shown in
BELT CHANGiNG AND AGITATOR
CLEANING section.

2. Push in and turn
bulb counterclock
wise, then pull out
to remove.

3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than

15 Watts(130 Volts),

4. Reinstall PowerMate cover as shown in

BELT CHANGING AND AGITATOR
CLEANING section

NOTE: See PARTS AND FEATURES for
Bulb number.

This manual is related to the following products: