I4. caring for the machine – Kenmore 1430 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
i4. CARING FOR THE MACHINE
CLEANING AND OILING
Fig. 1 Cleaning the feed dogs with a
brush.
To insure the best possible operation
of your machine, it is necessary to
keep the essential parts clean at ail
times. Using a small brush, remove
the lint that accumulates in the shuttle
area and around the feed dogs.
Fig. 2 Parts of the Shuttle Assembly
To Clean the Shuttle Area:
1. This area must be kept free of dust,
lint and occasional tangled thread.
Raise the needle bar to its highest
point and remove the bobbin case.
2. Push levers of shuttle race aside
and lift shuttle race cover and shut
tle out.
3. Clean the shuttle race with small
brush.
4. Put a drop of oil on the center pin
of the shuttle and shuttle race,
(see arrows)
To Replace Shuttle Assembly;
1 ■ Position shuttle race as illustrated so
that shuttle driver is forming half
moon on the left side of the
machine.
2. Hold shuttle by center pin and
position shuttle so as to form a half
moon on the right side. Pointed
hook will be on the bottom.
3. Place shuttle race cover into place
over shuttle assembly.
lever-
-lever
Shuttle Assembly
Shuttle Race Cover
Shuttle
driver
Shuttle Race
Fig. 2
43