beautypg.com

Connecting regulator to the lp tank, Lp tank leak test – Kenmore 146.1622201 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

LP Tank Exchange

Connecting Regulator To The LP Tank

' Many retailers that sell grills offer you the option of replacing

your empty LP tank through an exchange service. Use only
those reputable exchange companies that inspect, precision fill
test and certify their cylinders.

Exchange your tank only for

an OPD safety feature-equipped tank as described in the
"LP Tank" section of this manual.

’ Always keep new and exchanged LP tanks in upright position

during use, transit or storage.

' Leak test new and exchanged LP tanks BEFORE

connecting to grill.

LP Tank Leak Test

For your safety

• Leak test must be repeated each time LP tank is exchanged

or refilled r

• Do not smoke during leak test.
• Do not use an open flame to check for gas leaks.
• Grill must be leak tested outdoors in a well-ventilated area,

away from ignition sources such as gas fired or electrical
appliances. During leak test, keep grill away from open
flames or sparks.

• Use a clean paintbrush and a 50/50 mild soap and water

solution. Brush soapy solution onto areas indicated by arrows

in figure below. Leaks are indicated by growing bubbles.

If “growing” bubbles appear do not use or move the LP tank
Contact an LP gas supplier or your fire department!

ADo not use household cleaning agents.

Damage to the gas

train components (valve/hose/regulator) can result.

I

II*

V

1. LP tank must be properly secured onto grill. (Refer to

assembly section.)

2.

Turn all control knobs to the OFF position.

3.

Turn LP tank OFF by turning OPD hand wheel clockwise to a

full stop.

4.

Remove the protective cap from LP tank valve. Always use

cap and strap supplied with valve.

OPD Hand Wheel

-Type 1 outlet with

thread on outside

/

l

:.

M

strap and Cap

;. '.’V: \

' i! \ Do not insert a POL transport |

L

I (plastic part with external thre

plug

threads)

into the type 1 valve outlet. It will
defeat the Safety Relief Valve

feature.

5.

Hold regulator and insert nipple into LP

tank valve. Hand-tighten the coupling
nut, holding regulator in a straight line
with LP tank valve so as not to crossth-
thread the connection.

//

\

\\

Nipple has to be centered
into the LP tank valve.

\\ \ \

\\ ^

I

640-01303702-3-58-5