Sideburner – Kenmore 146.1622201 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sideburner
□
Loosen side burner in side shelf. To loosen, unscrew and remove two front screws and washers holding
sideburner in place. Note: Do not loosen electrode screw.
□
Remove knob and bezel from sideburner control valve. To remove, pull knob straight out from valve stem.
Unscrew bezel from valve face and set the two screws aside.
□
Insert valve stem through hole in fascia. Attach bezel to fascia and valve face with previously
removed 2 screws.
□
Place sideburner tube over the valve, making sure that valve is inside sideburner tube as shown.
□
Reattach sideburner to sideburner shelf with the 2 previously removed screws and washers.
□
Push control knob onto sideburner valve stem.
□
Replace sideburner grate.
□
Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.
□
Unscrew igniter cap from control panel. Insert (1) AA battery (not provided) into battery slot with
positive end (+) facing outward. Screw igniter cap back onto panel.
20-640-01303702-3-58