To clean agitator, Important – Kenmore 116.25812 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TO CLEAN AGITATOR:

NOTE:

In order to keep cleaning efficiency

high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is chanaed-

The agitator must aiso be cleaned accord
ing to the following schedule;

Vacuum Cleaner Use

HEAVY -

(used daily)

MODERATE -

(used 2-3 times/week)

LIGHT -

(used 1 time/week)

Clean Agitator

every week

every month

every 2 months

IMPORTANT

Disconnect vacuum cleaner from

electrical outlet.

Check and remove hair,

string and iint build-up frequently in the

Power-Mate® agitator and end cap areas.

Remove any dirt or debris in the belt path

area or in the brush roller area.

Carefully remove any string or debris
located on the agitator or end caps.

OCГOI AOtr

nCrLALrC DtnLI

1. Install new

belt over
motor drive,

then over
belt pulley.

Motor

Drive

Belt
Pulley

Agitator End Cap

NOTE:

See

PARTS AND FEATURES

for

Bell number.

2. Place agitator
assembly back into

Power-Mate®,

3. Line up
front of
cover and
base. Rest
cover on
front edge

U} Udoci db

shown.

Cover

4. NOTE:

On dirt sensor models be sure

that the board Is upright and the wires are
tucked back In place.

6. Turn Power-Mate upside down and
replace two (2) cover screws.